PYLE Audio DISC CD CHANGE instruction manual Installation, Location

Models: DISC CD CHANGE

1 12
Download 12 pages 45.05 Kb
Page 6
Image 6
INSTALLATION

INSTALLATION

Use the supplied parts and mount the unit securely. The use of parts other than these supplied (specified) may loosen or damage internal components.

If installation presents any difficulties, consult your dealer for advice.

Before drilling a hole into the wall or floor the vehicle trunk, check that nothing is behind the panel. Never drill a hole in the fuel tank or any other important that may be attached to the trunk.

Take off the negative terminal connector (–) of the car battery to prevent short circuits while you are installing the unit.

TOP

TOP

 

Proper

Improper

FRONT

FRONT

Location

Be sure to mount the unit in a location that will not interfere with the driver or passengers. Be certain there is not danger of passengers being injured case of sudden stops.

Do not mount the player near heater outlets, where it might be affected by heat; or near doors, where rainwater might splash onto it.

Do not mount the player in a location that will receive direct sunlight, such as on the dashboard or the rear shell. Excess heat will damage the player.

When mounting the player make sure no wires are trapped between the player and the surrounding metalwork or fittings.

Do not mount the player on the spare lire board or any other unstable place.

Do not mount the player where it will impede access to the spare tire, jack or tools.

Although the player can be mounted horizontally, vertically or at 45°, keep to the tolerable angles shown on following page. In addition, choose a place where the CD magazine can be loaded and unloaded easily.

5

Page 6
Image 6
PYLE Audio DISC CD CHANGE instruction manual Installation, Location