PYLE Audio PDWM4400 operation manual Audio Output Jack Volume Switch Belt Clip Battery Cover

Using the supplied audio cable, connect from the MIXED jack socket to the "MIC IN" / "LINE IN" socket on amplifier. Alternatively, you can connect an optional XLR cable from the "XLR MIXED" socket on the receiver to a professional mixer. Connect the mains power adaptor from "DC 15V" jack to a suitable mains power socket.

AUDIO OUTPUT JACK

VOLUME SWITCH

BELT CLIP

BATTERY COVER

Installation Location:

At least 3 ft. above ground level At Least 3 ft. away from wall

AUDIO SWITCH

LOW BAT

ON MUTE -20dB

POWER SWITCH

0dB OFF ON

9V +

MIC LINE MIC LINE MIC LINE MIC LINE MIC LINE

MIC/LINE AUDIO POWER ATTENUATION POWER

LOW BATTERY LED

POWER LED

ANTENNA

HEADSET MIC

LAVALIER MIC

MIXED

XLR MIXED

6

1.Open the battery cover to install a 9V battery (check polarities). Move the power switch to the ON position. The power indicator will be green to indicate normal operation. If the LOW BAT indicator turns red, replace with a fresh battery promptly.

2.Before operation, please confirm that the frequency of transmitter is same as the frequency of receiver. Plug the 3.5mm connector of headset mic to screw-lock socket of transmitter. Move the audio switch to ON position. The MUTE switch cuts off the audio output without shutting off the transmitter.

3.ATTENUATION is for volume adjustment. Move it to 0dB position to get normal volume output. Move it to -20dB position to reduce distortion and avoid feedback.

4.If the system will not be used for a long time, please switch off the transmitter to avoid power consumption.