PYLE Audio PFEVEX19010 user manual Firmly tighten, Exercise cycle for one, Be kept tightened

9. Identify the Left Pedal (24), which is marked with an							9
	“L.” Using an adjustable spanner,			firmly tighten		the
	Left Pedal	counterclockwise		into the Left Crank Arm
	(42). Tighten the Right Pedal (not shown)				clockwise
	into the Right Crank Arm.		Important: Tighten both
	Pedals as firmly as possible. After using the
	exercise cycle for one		week, retighten the
	Pedals. For best performance, the			Pedals must
	be kept tightened.						25
	Adjust the Left Pedal Strap (25) to the desired posi-							42
	tion, and press the end of the Pedal Strap onto the
							Tab
	tab on the Left Pedal (24). Adjust the Right Pedal							24
	Strap (not shown) in the same way.
10.	Make sure that all parts are properly tightened before you use the exercise cycle.							Note: After assembly is
	completed, some extra parts may be left over. Place a mat beneath the exercise cycle to protect the floor.

INSTALLING THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR

If you purchase the optional chest pulse sensor (refer to page 18), follow the steps below to install the receiver and the jumper wire included with the chest pulse sensor.

1.Remove the four indicated screws from the back of the Console (16). Lift off the front of the Console.

1

16

Lift Here

Short

Screws

Long

Screws

2.Plug the jumper wire (A) into the indicated jack on the Console (16). Connect the other end of the jumper wire

to the wire on the receiver (B). Note: Discard any

other wires included with the chest pulse sensor.

Next, peel the paper off the adhesive pad on the back

of the receiver (B). Orient the receiver as shown, and press it onto the Console (16) in the indicated location.

Refer to step 1 above. Reattach the front of the

Console (16) with the four screws. Make sure that no wires are pinched.

2	B
		Cylinder
	16
	Jack	A

8