OPERATION
GENERAL OPERATION
•SWITCHING ON/OFF THE UNIT
Switch on the unit by pressing any button (except EJECT button (7)). When system is on, press POWER button (1) to turn off the unit.
•SOUND ADJUSTMENT
Press SEL button (2) shortly to select the desired adjustment mode.
The adjustment mode will change in the following order:
| VOL |
|
|
| BAS |
|
|
| TRE |
|
|
| BAL |
|
|
| FAD |
|
| (Volume) |
|
| (Bass) |
|
| (Treble) |
|
| (Balance) |
|
| (Fader) | |||||
|
|
|
| |||||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
By rotating the audio knob (2) clockwise or
Press and hold the SEL button (2) for several seconds to adjust beep options, Rotate the audio knob (2) clockwise or
BEEP 2ND BEEP ALL BEEP OFF
-BEEP 2’nd mode:
The beep is only generated when double key is pressed for (1 sec). e.g.
When preset button (17) is pressed. When BND(LOU) button (11) is pressed. When
-BEEP ALL mode:
The beep is generated when any key is pressed.
-BEEP OFF mode: The beep is disabled.
LOUDNESS
Press BND/LOU/ENT button (11) for several seconds to reinforce the bass output. Press it for several seconds again to release this function.
MUTE
Press MUT button (23) to mute the sound instantly. Press any button to get out of mute mode.
EQUALIZATION
Press EQ button (5) to turn on equalization function and to select desired audio mode. There are five kinds of modes as shown below:
FLATCLASSICSPOP MROCK MDSP OFF
SUBWOOFER
Press MOD button (12) for several seconds to toggle
LIQUID CRYSTAL DISPLAY
Exhibits current frequency and activated functions on the display (4).
REMOTE SENSOR
Point the remote control handset to the remote sensor IR (6). Press the function keys on the handset to control the system.
ESP FUNCTION
If the unit has the electronic shockproof function, it can be shockproof for several seconds.
AUXILIARY INPUT
The unit can be connected to a portable audio player through the AUX IN jack (8) on the front panel. After finishing the connection, you can press MOD button
(12)on the front panel to switch the mode to AUX IN mode.
RESET FUNCTION
RESET button (24) must be activated with either a ballpoint pen or thin metal object. The RESET button is to be activated for the following reasons:
-Initial installation of the unit when all wiring is completed.
-All the function buttons do not operate.
-Error symbol on the display.
Note: If pressing the RESET button (24) does not work, please use a cotton swab soaked in isopropyl alcohol to clean the socket on the front panel.
8