PYLE Audio PLINV3 Symptom C The Low Output Of Inverter Is Measured, Possible Causes, Suggestion

Models: PLINV3 PLINV2 PLINV1

1 9

Page 8

POSSIBLE CAUSES	SUGGESTION

Battery voltage is too low below 10V DC	Recharge battery

The inverter is overload	Reduce load to 150 Watts (PINV1) , 300
	Watts (PINV2) and 400 Watts (PINV3)
	maximum to maintain regulation.

POSSIBLE CAUSES	SUGGESTION

The poor battery condition	Recharge battery

Inadequate power of excessive voltage drop	Check condition of battery clips and
	terminals. Clean or replace as necessary

Image 8

Contents

OWNER’S MANUAL POWER INVERTER PINV1 PINV2 PINV3PINV1 150WATT PINV2 300WATT PINV3 400WATTINTRODUCTION PINV2 / PINV3 FEATURESPINV1 CAUTION DO NOT USE THIS INVERTER WITH THE FOLLOWING The Power Source ConnectionOPERATION The LED indicators The ON/OFF switchThe fuse replacement The AC outletBATTERY OPERATING TIME SYMPTOMSPROTECTION PROTECTIONTROUBLE SHOOTING SYMPTOM A NO AC POWER OUTPUT, THE RED LED LIGHTSSYMPTOM B NO AC POWER OUTPUT, NO LED LIGHTS ARE ON POSSIBLE CAUSESSYMPTOM C THE LOW OUTPUT OF INVERTER IS MEASURED SYMPTOM D THE LOW BATTERY IS MEASUREDPOSSIBLE CAUSES SUGGESTIONSpecifications are subject to change and improvement without notice SPECIFICATIONSSpecifications are typical individual units might vary