paper feed roller inside the print mechanism then the paper will automatically advance to proper position (paper exit of print mechanism). In case there was a slip at the insertion of the leading end of paper roll and you want to keep same heading clearance, you may press the FEED button to advance the paper to position.
3.Close the top cover back. Should the front end of paper roll tend to curl as when it comes near end of the paper roll, it is advisable to press the FEED button to check if the paper comes out of the slot in top cover. Engage manual support to make sure it comes out if it fails.
D. SELF TEST
Press and hold down the feed button while turning on the power. The printer will then perform a self test and print out some major settings detected as in picture at right. You may turn off the power and turn it on again to resume normal use of the printer at this stage. You may also press the feed button at this moment to have the printer further print out some basic font used and a special pattern to have the self test proceedings completed as in the picture on next page. Please
note in the first part that both serial and parallel interfaces are indicated. That means the printer is working on an
2 - 5
