OPERATING PROCEDURES
2 | 3 | 4 | 5 | 1 |
1.POWER CORD
Plug this cord into a power socket before powering on the unit. If not using the unit for prolonged periods of time, please remember to turn it off and remove the cord from the socket.
2.USB PORT
Use the included USB cable to connect this port to an available USB port on your computer when transferring tapes.
3.GAIN KNOB
This knob can be used to adjust the audio signal from the unit to your computer. If you experience distortion and clipping when recording to your computer, we
PLAYBACK INSTRUCTIONS
PLAYING BACK A RECORDED TAPE:
1.Press the [STOP/EJECT] button to open the cassette holder.
2.Insert the tape and close the holder. If playing a Cr02 tape, press the Cr02 button.
3.If connected to an amplifier system, make sure the amplifier is turned on and adjust its volume to a suitable listening level.
4.Press the [PLAY] button to play the tape.
Please note: If you are transferring tapes to your computer, it is possible to hear your tapes through your computer’s soundcard or
recommend turning down the Gain. If the audio level from the unit is extremely low when recording to your computer, we recommend turning up the Gain.
4.REC INPUT
Connect a stereo RCA cable from an external source to this input. Please note that recording and dubbing only works on deck B.
5.PLAY OUTPUT
This is the combined audio output from deck A and deck B. Connect a stereo RCA cable from this output to the Line or Auxiliary input of a home stereo receiver system.
FAST FORWARDINGAND REWINDING:
1.While the deck is stopped, press the [FAST FORWARD] or [REWIND] button.
2.When the tape reaches the desired location, press [STOP/EJECT].
3.Press the [PLAY] button to play the tape from this location.
PAUSING:
1.Press the [PAUSE] button to pause the tape.
2.Press [PAUSE] again to release and resume playback.
STOPPING AND EJECTING:
1.Press the [STOP/EJECT] button while the tape is playing to stop playback.
2.Press [STOP/EJECT] again to eject the tape.
5
