Pyramid Car Audio PB717X, PB1217X, PB317X 4ch amp PB417X PB617X PB1617X, Electrical connections

electrical connections

4ch amp PB417X PB617X PB1617X

PB417X

PB617X

PB1617X

head unit

.

+12V battery 14

to remote turn-on +12V

features and specifications

4ch amp PB1617X

dual crossover mode selectors	when used with normal, full range systems, set this switch to “FULL”. If
	you wish the internal crossover to power a driver of specific frequency
	range , use the “LOWPASS” or “HIGHPASS” settings.
dual input level controls	use this control to match the outputs of you head unit to the amplifier.
	Starting with your head unit set at about the 2 o’clock position, increase
	the amp level control until distortion begins to occur, and reduce slightly
	from this point.
CH1/2 low pass frequency control	when the crossover selector switch is in “low pass” mode, this control
	sets the upper frequency limit for audio program sent to the speakers.
dual high pass frequency controls	when the crossover selector switch is in “high pass” mode, this control
	sets the upper frequency limit for audio program sent to the speakers.
CH1/2 bass boost level control	this control permits adjustment of the bass level up to an increase of
	approximately 18 dB.
dual level inputs	this amp features gold-plate RCA input jacks for high impedance input.
	Use these with car stereo output which uses RCA-type connector cables.
	if your car stereo lacks RCA-type output jacks, you may connect speaker
	output leads to these input connectors.
level output	use this control to match the speakers of the head unit to the amplifier.
power LED	this indicator is illuminated when power is applied.
protection LED	this indicator is illuminated when built-in protection circuitry is activated.
power fuse	the fuse protects the amplifier and your car’s electrical system from short
	circuit conditions.
power terminals	use these connectors to deliver power, ground and remote turn-on control
	to the amplifier.
dual speaker connections	these terminals are 14K gold plated to guarantee high conductivity and
	minimum signal loss.

output power@14.4v DC, 1KHz
RMS Power @ 4 ohms	75Watts	4
RMS Power @ 2 ohms	120Watts	4
Maximum Power Output	500Watts	4
frequency response	10Hz-70KHz
input impedance
low level inputs	10K Ohms
high level inputs	100 Ohms
input sensitivity	200 mV	11
low level inputs
high level inputs	5V
power supply voltage	14.4V DC Neg.Ground (10.5-16V)
matching speaker impedance
stereo mode	2-4 Ohms
bridged mode	4-8 Ohms
maximum current draw	30A 2

dimensions(W H L)

mm56 48 380

inches 2.24 1.92 15.2