Pyramid Car Audio PB1217X, PB717X, PB617X, PB1617X General features, Mounting and installation

general features

PB317X

High Performance 800Watt 2 channel Bridgeable MOSFET Amplifier

400	Watts	2 Output
800 Watts		1 Bridged Output

Variable Hi/Lo Electronic Crossover Network

Variable Bass Boost(0-6-+12dB@60Hz)

Variable Input Level(Gain)Control

Remote Turn on/Off

RCA Inputs

High Level MOLEX Indicator

Power ON LED Indicator

LED Protection Indicator

S/N Ratio: >95dB

THD :<0.2%

Thermal Protection

Overload Protection

Short Circuit Protection

Anti-Thump Turn-On

PB717X

High Performance 1000Watt 2 channel Bridgeable MOSFET Amplifier

500 Watts	2 Output
1000 Watts	1 Bridged Output

Variable Hi/Lo Electronic Crossover Network

Variable Bass Boost(0-6-+12dB@60Hz)

Variable Input Level(Gain)Control

Remote Turn on/Off

RCA Inputs

High Level MOLEX Indicator

Power ON LED Indicator

LED Protection Indicator

S/N Ratio: >95dB

THD :<0.2%

Thermal Protection

Overload Protection

Short Circuit Protection

Anti-Thump Turn-On

PB1217X

High Performance 1600Watt 2 channel Bridgeable MOSFET Amplifier

800 Watts	2 Output
1600 Watts	1 Bridged Output

Variable Hi/Lo Electronic Crossover Network

Variable Bass Boost(0-6-+12dB@60Hz)

Variable Input Level(Gain)Control

Remote Turn on/Off

RCA Inputs

High Level MOLEX Indicator Power ON LED Indicator

LED Protection Indicator2 S/N Ratio: >95dB

THD :<0.2%

Thermal Protection

Overload Protection

Short Circuit Protection

Anti-Thump Turn-On

mounting and installation

Your new PYRAMID Arctic Series amplifier comes complete with required mounting hardware. When determining a suitable location in your vehicle for the amp, please remember that it is a high- power electronic device capable of generating high heat.

For this reason, always choose a location in your vehicle which has low vibration, adequate ventilation, a minimum of dust, and no moisture.Be sure to mount the amp in such a manner as to allow reasonable airflow over the cooling fins.

Mark the location for the mounting screw holesby positioning the amp where you wish to install it and use a scribe (or one of the mounting screws) inserted in each of the mounting holes to mark the mounting surface for the mounting surface. If the mounting surface is carpeted, measure the hole centers and mark with a felt tip pen.

Before attempting to drill the mounting holes, take note of any wires, lines or otherdevices in your vehicle which may be located behind the mounting surface! Then drill pilot holes in the mounting surface for the mounting screws and insert them. Tighten the screws securely.

When making electrical connections to your amplifier, please observe the following: 23 Use at least 8 gauge wire for power and ground connections.

Wire the amplifier directly to the car battery.

For the ground connection, use the shortest possible wire to a good chassis ground point.

Wire the Remote connection to the auto start lead of your head unit, equalizer or power antenna.

About power fuses:

Pyramid Arctic Series amplifiers feature built-in fuse systems. These fuses protect both the amplifier and the electrical system in your vehicle from fault conditions. If you ever need to replace the fuse in your Pyramid Arctic Series amp, use a fuse of exactly the same type and rating. A different type or rating of fuse may result in damage or fire.