Q-Logic 8C manual SANbox2 admin # set setup snmp

￿	B – Command Line Interface
	Set Setup Command

Examples The following is an example of the Set Setup SNMP command:

SANbox2 $> admin start
SANbox2 (admin) #> set setup snmp
A list of attributes with formatting and current			values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press ’q’ or ’Q’ and the ENTER key to do so.
Trap Severity Options
---------------------
unknown, emergency,	alert, critical, error, warning, notify, info, debug, mark
Contact	(string, max=32	chars)	[Technical Support]
Location	(string, max=32	chars)	[TSLab	]
Trap1Address	(dot-notated IP	Address)	[10.20.71.15	]
Trap1Port	(decimal value)		[162	]
Trap1Severity	(see allowed options above)		[warning	]
Trap1Enabled	(True / False)		[True	]
Trap2Address	(dot-notated IP	Address)	[0.0.0.0	]
Trap2Port	(decimal value)		[162	]
Trap2Severity	(see allowed options above)		[warning	]
Trap2Enabled	(True / False)		[False	]
Trap3Address	(dot-notated IP	Address)	[0.0.0.0	]
Trap3Port	(decimal value)		[162	]
Trap3Severity	(see allowed options above)		[warning	]
Trap3Enabled	(True / False)		[False	]
Trap4Address	(dot-notated IP	Address)	[0.0.0.0	]
Trap4Port	(decimal value)		[162	]
Trap4Severity	(see allowed options above)		[warning	]
Trap4Enabled	(True / False)		[False	]
Trap5Address	(dot-notated IP	Address)	[0.0.0.0	]
Trap5Port	(decimal value)		[162	]
Trap5Severity	(see allowed options above)		[warning	]
Trap5Enabled	(True / False)		[False	]
ReadCommunity	(string, max=32	chars)	[public	]
WriteCommunity	(string, max=32	chars)	[private	]
TrapCommunity	(string, max=32	chars)	[public	]
AuthFailureTrap	(True / False)		[False	]

Do you want to save and activate this snmp setup? (y/n)

59042-01 A B-39