CONNECTIONS- Post Processor Outputs
Post Processor Outputs
Each processor has two
These are electronically balanced outputs with an impedance of 600 ohms with the shield terminal connected to the chassis. The outputs are suitable for daisy chaining the post processor signal on to other devices in the system. We recommend that no more than five balanced,
The output connectors on the Processors are three pin terminal block connectors. They are sometimes called “Phoenix- or
The appendix provides part number information on these connectors.
Top Box Processor- Both CH1 and CH2 OUTPUTs are active for most applications. The signal output from each connector is same as the signal applied to the inputs of the top box amplifier.
Subwoofer Processor- Use CH1 OUTPUT only. CH1 OUTPUTs signal is the same signal applied to the input if the subwoofer amplifier. CH2 OUTPUT is not normally used.
The post processor outputs are recessed, located on the processor faceplates. Each processor has post processor outputs suitable for daisy chaining the processed audio on to other devices in your system using detachable terminal block connectors.
NOTES: The output levels of each processor are dependant on your settings in the Signal Manager
software when you configure the processor. If post processor outputs do not behave as expected,
connect your host PC to the processor and verify your configu- ration.
QSC recommends the use of balanced audio connections exclusively. We discourage the use of unbalanced connections as they are more prone to
Subwoofer
Balanced connection. | Unbalanced connection. | |||||
|
|
|
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Terminal Block
Connector Pinouts
16
