QSC Audio WL 2102 Input Connections, Neutrik NL8FC Cable Connector Pinout, Two Way, Three Way

Input Connections

The input connectors are a pair of Neutrik NL8's wired in parallel. Connections for biamp and tri- amp vary, see Table 1. The pin designations for the NL8FC cable connector is shown for reference, bottom right.

Note! In three way mode, the Low Frequency Select switch position determines the input connector wiring! Unexpected results may occur if switch positions and wir- ing are not strictly controlled.

The WideLine loudspeaker is not equipped with a crossover network. All signal processing must be done before connecting audio power to the loudspeaker. Do not connect full-range audio to the high-frequency transducer or damage may result!

Table 1: Input Connector Wiring, Two way and Three Way Modes

	Two Way	Three Way	Three Way
	Internal Shading	Use External	Use External
Pin	Network Inserted in	Processing for	Processing for
	Signal Path	Shading, LF Select	Shading, LF Select
		Switch Position A	Switch Position B
1+	LF +	LF A +	LF B +
1-	LF -	LF A -	LF B -
2+	Not Used	LF B +	LF A +
2-	Not Used	LF B -	LF A -
3+	Not used	Not used	Not used
3-	Not used	Not used	Not used
4+	HF +	HF +	HF +
4-	HF-	HF-	HF -

Neutrik NL8FC Cable Connector Pinout

Below is a diagram showing the pin designation inside the Neutrik NL8FC connector. This informa- tion is for reference only. Diagram is of the connector as viewed from the wire-insertion end.

NL8FC pin designations- Plug viewed from the wiring side.

5