9Maintenance and Service
A. Access the Firebox
•Turn the heater off and turn off the circuit breaker.
•Allow the heater to cool before cleaning.
•Remove the front face to access the log area.
-Remove the screws from the switch bracket.
-Remove by pulling out the bottom of the front and then lifting up
•Replace all parts after cleaning or bulb replacement has been completed.
•Reset the circuit breaker.
WARNING
Shock Risk
Burn Risk
Cleaning, performing maintenance or moving this electric heater without disconnecting power and allowing the heater to cool could create a shock or burn hazard.
•Turn controls to “OFF”.
•Remove plug from outlet or turn off the circuit breaker to the heater.
B. Clean the Firebox Compartment
Use the brush attachment and gently vacuum the compart- ment.
C. Clean the Back Acrylic Panel
•The panel is cleaned in the factory during the assembly process. During shipment, installation, handling, etc., the surface may collect dust particles. These can be removed by buffing lightly with a clean dry cloth.
•To remove fi ngerprints or other marks, the panel can be
cleaned with a damp cloth using a mild soap and water | Hearth |
|
| ||
solution. DO NOT USE GLASS CLEANER! IT WILL | Assembly | |
DAMAGE THE BACK ACRYLIC PANEL. The panel |
|
|
should be completely dried with a lint free cloth or paper |
|
|
towel. |
|
|
D. Replace the Light Bulbs |
| Bulbs |
The light bulbs need to be replaced when the fl ame and/or |
|
|
ember bed is dark on one side. Replace the bulbs with 75 | Figure 9.1 - Bulb Access |
|
watt halogen bulbs with |
| |
|
| |
exceed 75 watts per bulb. Light bulbs can be purchased at a |
|
|
local hardware or lighting store, |
|
|
ommend you use Sylvania model SL58884 or Satco model |
|
|
S3157. |
|
|
• Light bulb access is through the hearth assembly. See |
|
|
Figure 9.1. |
|
|
• Locate and lift the bent tabs holding the hearth assembly |
|
|
located at each end of the assembly. |
|
|
• Lift out the hearth assembly. |
| Sockets |
• Carefully remove the burned out bulb from the light socket. |
| |
|
| |
Place the new bulb in the socket. See Figure 9.2. Follow |
|
|
directions on the light bulb package for handling |
|
|
requirements. |
|
|
• Reinstall the hearth assembly. |
|
|
|
| Bulbs |
| Figure 9.2 - Replacing the Bulbs | |
17 | ||
