Mount Command Options
StorNext File System Tuning
The Metadata Controller System
slower CPU.) Differences in latency over time for the same system can indicate new hardware problems, such as a network interface going bad.
If a latency test has been run for a particular client, the cvadmin who long command includes the test results in its output, along with information about when the test was last run.
The following SNFS mount command settings are explained in greater detail in the mount_cvfs man page.
The default size of the buffer cache varies by platform and main memory size, and ranges between 32MB and 256MB. And, by default, each buffer is 64K so the cache contains between 512 and 4096 buffers. In general, increasing the size of the buffer cache will not improve performance for streaming reads and writes. However, a large cache helps greatly in cases of multiple concurrent streams, and where files are being written and subsequently read. Buffer cache size is adjusted with the buffercachecap setting.
The buffer cache I/O size is adjusted using the cachebufsize setting. The default setting is usually optimal; however, sometimes performance can be improved by increasing this setting to match the RAID5 stripe size.
Using a large cachebufsize setting decreases random I/O performance when the amount of data being read is smaller than the cache buffer size.
Buffer cache
buffercache_readahead setting. When the system detects that a file is being read in its entirety, several buffer cache I/O daemons
The auto_dma_read_length and auto_dma_write_length settings determine the minimum transfer size where direct DMA I/O is performed instead of using the buffer cache for
For example, if buffer cache I/O throughput is 200 MB/sec but 512K DMA I/O size observes only 100MB/sec, it would be useful to determine which DMA I/O size matches the buffer cache performance and adjust auto_dma_read_length and auto_dma_write_length accordingly. The lmdd utility is handy here.
StorNext File System Tuning Guide | 19 |
