V . C O M F O R T A D J U S T M E N T S
COMFORT ADJUSTMENTS
After becoming familiar with your power chair’s operation, you may find the need to make some adjustments to increase your comfort, such as seat height and angle, armrest width, armrest angle and height, leg rest position, and controller position.
NOTE: If your power chair is equipped with a Specialty Seat, Synergy Seating System, or
WARNING! The center of gravity of your power chair was factory set to a position that meets the needs of the demographic majority of users. Your Quantum Rehab Provider has evaluated your power chair and made any necessary adjustments to suit your specific requirements. Do not change your seating configuration without first contacting Pride Mobility Products or your Quantum Rehab Provider.
WARNING! Some power chair components are heavy. You may need assistance to lift or carry them. Please refer to the specifications table for specific component weights before you disassemble the power chair.
WARNING! Remove the occupant from the power chair before making any adjustments.
You may need the following to make comfort adjustments:
metric/standard hex key set metric/standard socket set and ratchet adjustable wrench
Seat Height and Seat Angle Adjustment
The seat is attached to the power base through the UMS. See figure 12. You can change the seat height to one of three positions by raising the front and rear trapeze bars. If you raise or lower only one trapeze bar (front or rear), you can also change the seat base angle (dump).
NOTE: It is easier to raise/lower the trapeze bars with the seat removed.
To change the seat height or seat angle:
1.Power off the controller.
2.Make sure the power chair is in drive mode.
3.If the controller connector is located at the rear of the power base, release the battery door latches and open the battery door.
4.Disconnect the controller connector. See figure 6 or 7.
5.Flip up the seat latch safety to release the seat from the front trapeze bar. See figure 15.
6.Slide the seat forward and lift it off the power base. Set it aside.
7.Remove the bolt and nuts from the rear trapeze bar. See figure 16.
8.Raise or lower the rear trapeze bar to the desired position.
9.Reinstall the bolt and nuts into the rear trapeze bar.
Figure 15. Seat Latch Safety
BOLT AND | REAR TRAPEZE BAR | BOLT AND |
NUT | ||
|
| NUT |
Figure 16. Rear Trapeze Bar Adjustment
Quantum | www.pridemobility.com | 23 |