V . C O M F O R T A D J U S T M E N T S
Seatback Angle Adjustment
If your power chair is equipped with an adjustable seatback, you can adjust it to four (4) different angles: 90°, 102°, 105°, or 107°.
To adjust the seatback angle:
1.Remove the adjusting screws from each seat hinge. See figure 18.
2.Set the seatback at the desired angle.
3.Reinstall the adjusting screws to each seat hinge and tighten.
Armrest Width Adjustment
You can change each armrest’s width independently of the other.
NOTE: Changing the armrest width may increase the overall width of your power chair.
To change the armrest width:
1.Locate the two armrest knobs on each side of the armrest receiver bracket. See figure 18.
2.Loosen the knobs.
3.Slide the armrests in or out to the desired width.
4.Tighten the knobs.
Armrest Angle Adjustment
To change the armrest angle:
1.Lift the armrest straight up so that it is perpendicu- lar to the floor. See figure 18.
2.Loosen the jam nut.
3.Turn the adjusting screw to lower the front of the armrest or to raise the front of the armrest.
4.Tighten the jam nut to lock the adjusting screw into place.
Armrest Height Adjustment
To change the armrest height:
1.Loosen the two setscrews located on the armrest receiver. See figure 18.
2.Raise or lower the armrest to the desired height.
3.Tighten the setscrews to secure the armrest.
JAM NUT |
ARMREST ANGLE |
ADJUSTING |
SCREW |
ARMREST HEIGHT |
ADJUSTING |
SETSCREWS |
SEATBACK ANGLE |
ADJUSTING SCREW |
ARMREST KNOB |
Figure 18. Seatback/Armrest Adjustment
Quantum | www.pridemobility.com | 25 |
