V . C O M F O R T A D J U S T M E N T S
Controller Position
You can move the controller in toward or out away from the armrest, or change the position of the control- ler for either
WARNING! Do not place the controller harness so that it can be pinched in the seat frame or the power base frame.
To extend the controller:
1.Flip up the armrest so it is perpendicular to the floor.
2.Loosen the setscrew on the controller bracket. See figure 19.
3.Slide the controller into or out of the armrest to the desired position.
4.Tighten the setscrew to secure the controller.
NOTE: If your power chair is equipped with a Spe- cialty Seat, Synergy Seat, or
CONTROLLER BRACKET
SETSCREW
Figure 19. Underside of Armrest
To change the controller position:
1.Turn off the power to the controller.
2.Release the battery door latches and open the bat- tery door if necessary.
3.Unplug the controller connector from the power base.
4.Remove any wire ties securing the controller harness to the armrest.
5.Flip up the armrest so it is perpendicular to the floor.
6.Loosen the setscrew on the controller bracket.
7.Slide the controller out of the armrest.
8.Loosen the setscrew in the other armrest.
9.Place the controller in the other armrest.
10.Tighten the setscrew to secure the controller.
11.Route the controller harness to the front or back of the power base and plug in the controller. See fig- ure 6 or 7.
12.Close the battery door and secure the latches if nec- essary.
13.Secure the controller harness to the armrest with wire ties. See figure 14.
NOTE: If your power chair is equipped with a Spe- cialty Seat, Synergy Seat, or
MOUNTING BLOCK |
MOUNTING SCREWS |
SETSCREWS |
Figure 20. Adjusting Controller Position (Standard Seat)
26 | www.pridemobility.com | Quantum |