SuperLoader™ 3A Series Quick Start Guide
Caution: Do not remove the top cover of the autoloader during the installation process. Removing the top cover could result in damage to the autoloader.
Unpacking the Autoloader
Before you begin, clear a desk or table so that you can unpack the autoloader.
The SuperLoader 3A Series Quick Start Guide has all the necessary information to unpack and inspect your autoloader correctly.
You also need to select an open 2U computer rack location near the server that will host the autoloader.
Caution: If the room in which you are working differs from the temperature in which the autoloader was shipped or stored by 15° C (30° F) or more, let the autoloader acclimate to the surrounding environment for at least 12 hours before removing it from the shipping carton.
Caution: If your unit was ordered as a
Carefully unpack and inspect your new SuperLoader 3A Series autoloader by doing the following:
1Inspect the shipping box for damage. If you notice any damage, report it to the shipping company immediately.
2Open the shipping box and remove the accessories package. Set the accessories package aside for now.
3Lift the autoloader and padding out of the box and place it on the work surface, top facing up. Do not set the autoloader on either end or sides.
4Carefully remove the shipping padding from the left and right sides of the autoloader. Then remove the bag from the autoloader.
5Remove the foam insert from the magazine bay of the autoloader. Save the packing materials in case you need to move or ship the autoloader in the future.
Note: If the cover must be taken off, there are 26 screws that need to be removed.
4 | Unpacking the Autoloader |
