SuperLoader™ 3A Series Quick Start Guide
Rack Mounting the Autoloader
This section provides the steps for attaching the autoloader directly to the stationary rails of a rack. Refer to table 1 for information on common rack hole types.
Table 1 Rack Hole Types
Figure | Description |
| Square rack holes are the most |
| common type of rack holes. |
| They can accept either cage |
Cage nut | nuts which mount from the back |
of the rail or clip nuts which clip | |
| on from the side of the rack rail. |
Clip nut |
|
Clip nut | Through holes require clip nuts |
to accept mounting hardware. |
Threaded holes require neither cage or clip nuts to accept mounting hardware.
Note: The rails within the rack have a hole pattern that repeats throughout the rail.
1Install two clip nuts, 1.75 in. (44.45 mm) apart, onto each of the four rails of the rack, making sure that you install each pair of clip nuts at exactly the same level (see figure 2).
6 | Rack Mounting the Autoloader |
