Manuals / Quatech / Computer Equipment / Network Card

Quatech DSCLP-100 user manual Specifications

Models: DSCLP-100

1 32

Download 32 pages 10.55 Kb

Page 29

9 Specifications

Bus interface:		PCI, 32-bit bus, 5-volt only
		IBM-compatible computers
Dimensions:		approx. 5.0" x 3.7"
Serial ports
Controller:		16550 with 16-byte FIFOs
Interface:		One male D-25 connector
		Two male D-9 connectors
		using adapter cable
Transceivers:		ICL3245CA
High-level output: +5V min
Low-level output: -5V max,
Switching speed
Power requirements
+3.3	volts:	approx. 250 mA
+/-12 volts:		approx. 35 mA
Temperature:		operating 0° to 70°
		storage -50° to 80°
Humidity:		10% to 90%

24	DSCLP/SSCLP-100 User's Manual

Image 29

Quatech DSCLP-100 user manual Specifications

Contents

Users Manual DSCLP/SSCLP-100Two Channel Low Profile RS-232 Asynchronous Communications Adapter for PCI bus? 2002, Quatech, Inc DATE OF PURCHASE WARRANTY INFORMATIONMODEL NUMBER DSCLP-100 or SSCLP-100Manufacturers Address Manufacturers NameApplication of Council Directive Standards to whichUsing the New Hardware Found Wizard Table of ContentsViewing Resources with Device Manager DOS and other operating systems1 General Information 2.1 Factory Default Configuration 2 Hardware Configuration2.2 Enable Scratchpad Register SPAD, J2 2.3 Force High-Speed UART Clock X2 or X4, J4-J5Baud rates up to 230.4 kbps Figure 5 --- Jumper/connector locations 3 Hardware InstallationDSCLP/SSCLP-100 Users Manual This page intentionally blank4.1 Base Address and Interrupt Level IRQ 4 Address Map and Special RegistersPort I/O Address Range4.2 Enabling the Special Registers address 7 accesses4.3 Interrupt Status Register DLAB Bit4.4.1 Enhanced Serial Adapter Identification 4.4 Options RegisterName WriteClock Rate 4.4.2 Clock Rate MultiplierUART Clock Maximum Data5.1 Windows Millennium 5 Windows Configurations5.2 Windows 5.3 Windows 5.4 Windows 5.5 Using the New Hardware Found Wizard 5.6 Viewing Resources with Device Manager DSCLP/SSCLP-100 Users Manual DSCLP/SSCLP-100 Users Manual Figure 13--- Windows 95 Device ManagerDSCLP/SSCLP-100 Users Manual Figure 14 --- Windows 95 Device Manager6.1 Windows NT 6 Other Operating Systems6.2 OS/2 6.3 DOS and other operating systemscannot be used to make changes DSCLP/SSCLP-100 Users Manual Figure 15 --- QTPCI.EXE Expert Mode display7 External Connections RS-232 SignalPort Port8 PCI Resource Map 9 Specifications Data Rate Maximum Load pFkbaud transCannot communicate with other equipment 10 TroubleshootingComputer will not boot up SSCLP/DSCLP-100 Users Manual Revision January P/N