Manuals
/
Quatech
/
Computer Equipment
/
Network Card
Quatech
user manual SSCLP/DSCLP-100 Users Manual Revision January P/N
Models:
DSCLP-100
1
32
32
Download
32 pages
10.55 Kb
25
26
27
28
29
30
31
32
<
>
Troubleshooting
Specifications
Install
Warranty
Hardware Configuration
Signal
address 7 accesses
Windows 5.5 Using the New Hardware Found Wizard
QTPCI.EXE Expert Mode display
Page 32
Image 32
SSCLP/DSCLP-100
User's Manual
Revision 1.00
January 2002
P/N:
940-0179-100
Page 31
Page 32
Image 32
Page 31
Contents
DSCLP/SSCLP-100
Users Manual
Two Channel Low Profile RS-232 Asynchronous Communications Adapter
for PCI bus
? 2002, Quatech, Inc
WARRANTY INFORMATION
DATE OF PURCHASE
MODEL NUMBER
DSCLP-100 or SSCLP-100
Manufacturers Name
Manufacturers Address
Application of Council Directive
Standards to which
Table of Contents
Using the New Hardware Found Wizard
Viewing Resources with Device Manager
DOS and other operating systems
1 General Information
2 Hardware Configuration
2.1 Factory Default Configuration
2.2 Enable Scratchpad Register SPAD, J2
2.3 Force High-Speed UART Clock X2 or X4, J4-J5
Baud rates up to 230.4 kbps
3 Hardware Installation
Figure 5 --- Jumper/connector locations
This page intentionally blank
DSCLP/SSCLP-100 Users Manual
4 Address Map and Special Registers
4.1 Base Address and Interrupt Level IRQ
Port
I/O Address Range
address 7 accesses
4.2 Enabling the Special Registers
4.3 Interrupt Status Register
DLAB Bit
4.4 Options Register
4.4.1 Enhanced Serial Adapter Identification
Name
Write
4.4.2 Clock Rate Multiplier
Clock Rate
UART Clock
Maximum Data
5 Windows Configurations
5.1 Windows Millennium
5.2 Windows
5.3 Windows
5.4 Windows 5.5 Using the New Hardware Found Wizard
5.6 Viewing Resources with Device Manager
DSCLP/SSCLP-100 Users Manual
Figure 13--- Windows 95 Device Manager
DSCLP/SSCLP-100 Users Manual
Figure 14 --- Windows 95 Device Manager
DSCLP/SSCLP-100 Users Manual
6 Other Operating Systems
6.1 Windows NT
6.2 OS/2
6.3 DOS and other operating systems
cannot be used to make changes
Figure 15 --- QTPCI.EXE Expert Mode display
DSCLP/SSCLP-100 Users Manual
7 External Connections
Signal
RS-232
Port
Port
8 PCI Resource Map
9 Specifications
Maximum Load pF
Data Rate
kbaud
trans
Cannot communicate with other equipment
10 Troubleshooting
Computer will not boot up
SSCLP/DSCLP-100 Users Manual Revision January P/N
