Quatech DSCLP-100 user manual Hardware Installation, Jumper/connector locations

3Hardware Installation

1.Turn off the power of the computer system in which the DSCLP-100 is to be installed.

2.Remove the system cover according to the instructions provided by the computer manufacturer.

3.Make any desired optional jumper setting changes.

4.Install the DSCLP-100 in any empty PCI expansion slot. The board should be secured by installing the Option Retaining Bracket (ORB) screw.

5.Replace the system cover according to the instructions provided by the computer manufacturer.

6.Attach and secure the cable connectors to the desired equipment.

7.Turn on the power of the computer system.

The output of the DSCLP-100 is a 25-pin D-connector. A cable is provided to convert the D-25 into two standard male D-9 connectors with all control signals provided to each port (RTS, DTR, CTS, DSR, DCD, and RI).

Clock multiplier/
scratchpad select
J 2	SPAD
J 4	X4
J 5	X2
Figure 5 --- Jumper/connector locations

4 DSCLP/SSCLP-100 User's Manual