(Continued) If you cannot eliminate the interference, the FCC requires that you stop using your radio.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Ô NOTE Ô

To mount the radio on a wall, you need two screws (not supplied, available at your local RadioShack store) with heads that fit the keyhole slots on the bottom of the radio.

1. Insert the supplied adapter’s barrel plug into the DC 6V500mA

jack on the back of the radio.

2.Route the adapter cord into the groove on the back of the radio.

3.Plug the adapter into a standard AC outlet.

4.Raise the antenna to a vertical position.

MOUNTING ON A WALL

1.Drill two holes 23/4-inches apart. Then thread a screw into each hole, letting the screw heads extend about 1/8-inch from the wall. Ô

Strain23/4-inReliefGroove

6