15-1993.fm Page 7 Wednesday, October 20, 1999 12:03 PM

4.Point the remote control at your device and press POWER. Your device should turn off (or on, if it was off).

If the remote does not operate your device, try the other codes listed in “Manufacturer Codes” on Page 17 for your brand of TV, VCR, cable converter, or CD player.

5.Repeat Steps 2–4 for additional devices.

TO OPERATE YOUR TV/VCR COMBINATION

1.Locate the codes for your TV/VCR combi- nation in “TV/VCR Combinations” on Page 34 and write them on the 4-in-One’s label.

2.Press VCR. The red light blinks.

3.Hold down P until the red light blinks twice, then enter the 4-digit manufacturer's code.

When the red light blinks twice, the remote control has accepted the code.

Note: If the code you entered is invalid, the red light blinks.

4.Point the remote control at your TV/VCR combination and press POWER. Your device should turn off (or on, if it was off).

If the remote does not operate your device, try the other codes you wrote down in Step 1.

Note: Some TV/VCR combinations require a second code to control volume. If you cannot control the volume, use the TV code listed in “TV/VCR Combinations” on Page 34.

7

Page 7
Image 7
Radio Shack 4-in-One Smart Light-Up Remote Control owner manual To Operate Your TV/VCR Combination