15-1993.fm Page 15 Wednesday, October 20, 1999 12:03 PM

If necessary, repeat these steps for each de- vice.

Note: Some VCRs and CD players do not have a POWER key on the original remote. If so, manually turn on the VCR, insert a tape or CD, and repeat the manual code search using PLAY instead of POWER. When the device responds, press P. The red light blinks twice.

Determining the 4-Digit Code

After you set up your remote control using the manual code search, you can find which 4-digit code the remote control is set to by following these steps.

1.Press the device key you want to get the manufacturer's code from, then hold down P until the red light blinks twice.

2.Press 9 9 0. The red light blinks twice again.

3.Press 1, then count the number of times the red light blinks. This is the first digit of the 4-digit code.

Note: If the red light does not blink, the digit is a 0.

4.Repeat Step 3 three times to find the sec- ond, third, and fourth numbers of the 4- digit manufacturer's code, pressing 2, 3, and 4 respectively for each additional digit.

15

Page 15
Image 15
Radio Shack 4-in-One Smart Light-Up Remote Control owner manual Determining the 4-Digit Code