Installation | Radio Shack 43-3548 specification

! IMPORTANT !

Be sure the battery pack is properly connected before you try to charge it. The CHARGE/IN USE indicator lights when the handset is on the base, even if the battery pack is not connected.

Installation

•If the base loses power for about an hour while the handset is away from it, the security access-protection code might be lost. To change the code, while holding PAGE, return the handset to the base for about 3 seconds.

•If the battery pack becomes weak during a call, the handset beeps every 3 seconds and Low Battery ﬂashes. When this happens, you cannot make a call until you recharge the battery pack.!

•If the display is blank and the phone does not work, recharge the battery pack. (The battery power might be too low to light the display.)

•About once a month, fully discharge the battery by keeping the handset off the base until Low Battery ﬂashes on the display. Otherwise, the battery pack loses its ability to fully recharge.

•The handset loses its security access- protection code if the battery pack is completely discharged. While holding PAGE, place the handset on the base to recharge the battery pack and change the code.

•Using a pencil eraser, clean the charging contacts on the handset and base about once a month.

•If you are not going to use your phone for an extended period, disconnect the battery pack. This increases the battery pack’s usable life.

12

Image 12

Radio Shack 43-3548 owner manual Installation

Contents

GHz Cordless Telephone Caller ID/Call Waiting ID Contents Information Contents Important Safety Instructions Battery Safety Instructions Important Safety Instructions Introduction Installation Selecting a Location On a Desk Top On a Wall Plate On a Wall Recharging the Battery Pack CONNECTING/CHARGING the Battery Pack Installation Operation Making and Receiving Calls Handset ringer tone and volume Earpiece volumeAdjusting the Handset Ringer and Earpiece Volume Tone Dialing SWITCH-OVER Temporarily Mute RingerRedial Traveling OUT-OF-RANGE Voice Mail Waiting Indicator Voice Mail Waiting IndicatorSelecting a Different Channel Flash and Call Waiting Setting Menu Options Auto TalkCaller ID options Choosing the dialing mode Choosing the dialing modeArea Code Area Code Setting the language Storing Phone Numbers and Names Storing Phone Numbers and Names Steps for Entering Names and Special Characters Memory dialing from Standby Mode Memory dialing from Talk ModeMemory dialing from Standby Mode If you make a mistake while entering a name Memory dialing from Talk Mode Chain DialingEditing a Stored Name AND/OR Phone Number Operation Erasing a Stored Name and Phone Number Testing Stored Emergency Numbers ONE-TOUCH Speed DialStoring and Editing the Speed Dial Making Calls with Deleting the Speed DialCaller ID When the Telephone Rings You may receive any one of the following messages Deleting a Caller ID message Viewing the Caller ID Message ListDeleting Information from the Caller ID List Viewing the Caller ID Message List Using the Caller ID List Deleting all Caller ID names/ numbers ÔCalling a party from the Caller ID list Deleting all Caller ID names/numbers You cannot make a call Long Distance calls and Area Code Setting/Cancellation Long Distance calls and Area Code Setting/ CancellationStoring Caller ID messages in Memory dialing Storing Caller ID Messages in Memory dialog Using a Headset Troubleshooting Problem Solution Service and Repair Care RadioShack Corporation