|
| Problem | Solution |
|
|
| The incoming messages may be too long. Remind callers to |
Troubleshooting |
| Messages are | leave a brief message. |
| incomplete. | The memory may be full. Delete some or all of the saved | |
|
| ||
|
|
| messages. |
|
| After a power failure, the | Record your personal outgoing message again. The default |
|
| outgoing message is | |
|
| message should remain. | |
|
| deleted. | |
|
|
| |
|
| No sound on the base |
|
|
| unit speaker during call | Adjust the speaker volume on the base unit. |
|
| monitoring or message | |
|
|
| |
|
| playback. |
|
|
| Cannot access remote | Make sure you’re using the correct PIN code. |
|
| Make sure that the | |
|
| another | the tone for at least two seconds. If it cannot, you may have to |
|
| use another phone to access your messages. | |
|
|
|
|
If you still have problems, disconnect the phone. If other phones on the same line work properly, the fault is in this phone or its installation. If you cannot find the problem, take your phone to your local RadioShack store for assistance.
34