Installation
3.Insert the supplied AC adapter’s barrel plug into the DC IN 9V jack on the back.
4.Route the adapter’s cord through the strain relief slot on the base’s bottom.
5.Plug the adapter into a standard AC outlet.
6.Lift the base’s antenna to a vertical position.
On a Wall Plate or Wall
To mount the phone directly on a wall, you need two screws (not supplied) with heads that fit into the keyhole slots on the base. Drill two holes 315/16 inches apart. Thread a screw into each hole, letting the heads extend about 1/8 inch.
1. Insert the two tabs at the top of the narrow end of the supplied bracket into the base’s upper tab slots, then press down on the bracket’s latches and insert them into the lower slots.
2. Plug one end of the supplied modular cord (short for a wall plate, long for direct wall mounting) into the TEL LINE jack on the base’s back.
3. Insert the | DC IN 9V | TEL LINE | |
supplied AC | |||
|
| ||
adapter’s barrel |
|
| |
plug into the DC |
|
| |
IN 9V jack. |
|
|
4. Route the adapter and modular cords through the base’s grooves.
8
