34
REPLACING THE DOOR/WINDOW SENSOR TRANSMITTERS’ BATTERIES
If any of the console’s zone indicators
flash slowly, the door/window sensor
transmitter or motion detector for that
zone has not reported in during the last
4 hours. This is most likely caused by
a dead battery.
Replace the door/window sensor
transmitter or motion detector’s bat-
tery, then follow these steps to confirm
that the console still recognizes it.
1. Set INSTALL/RUN 1/RUN 2 on the
console to RUN 2.
2. Press TEST on the sensor trans-
mitter or motion detector.
If the console chimes, it recognizes the
sensor transmitter or motion detector.
If you do not hear a chime when you
press TEST:
1. Set INSTALL/RUN 1/RUN 2 on the
console to INSTALL.
2. Press TEST. The sensor transmit-
ter transmits a code to the con-
sole, and the console chimes to
confirm it accepted the code.
When you press TEST, the system
assigns the sensor transmitter to
the first available zone. If a zone’s
indicator is flashing (to indicate
that zone’s sensor transmitter has
not reported in in the last 4 hours),
the zone is considered available.
INTERCOM SYSTEMS
Intercom systems which send voice
signals over existing electrical wiring
might interfere with the ability to control
Plug ´n Power modules from your se-
curity system when the intercom is in
use.
If the intercom system has separate
wiring, it does not cause a problem.
49-2570.fm Page 34 Wednesda y, August 18, 1999 3:59 PM