30
Problem Solution
You do not hear a chime from
the console when you press
ARM to install a remote.
Check if you can arm the system when INSTALL/RUN 1/
RUN 2 on the console is set to RUN 1 or RUN 2. If you can,
the remote control is already installed and no further ac-
tion is necessary . If not:
1. Set INSTALL/RUN 1/RUN 2 on the console to
INSTALL.
2. Press
CODE (located beneath the label on the
remote control) with a pencil, then press ARM a
g
ain.
You do not hear a chime from
the console when you press
TEST to install a door/window
sensor transmitter or motion
detector.
With
INSTALL/RUN 1/RUN 2 on the console set to RUN 2,
check that the console chimes when you press TEST on
the sensor transmitter or motion detector. If it does, the
sensor transmitter or motion detector is already inst all ed
and no further action is necessary. If not:
1. Set INSTALL/RUN 1/RUN 2 on the console to
INSTALL.
2. Press CODE on the motion detector with a pencil or
remove then reinstall the batteries in the sensor
transmitter. Then press TEST a
g
ain.
Note: If the sensor transmitter/motion detector is alr eady
installed, it is in st al led a
g
ain into the next available zone.
The BATTERY LOW indicator
on the console is on. Replace the console’s battery.
You lose your remote control. Purchase a replacement remote control (Cat. No. 49-
2591T or 49-2591), and then completely re-install your
system to prevent someone else from usin
g
the lost re-
mote control.
The system arms or disarms
by itself. A nei
g
hbor mi
g
ht have a compatible system. Re-install
the remotes.
The red indicator on the hand-
held remote control stays on
durin
g
installation .
Press the button located beneath the label with a pencil
and then press ARM. If it still stays on, remove the bat-
tery, wait a few seconds, then replace the battery. Press
the button and then ARM a
g
ain.
49-2570.fm Page 30 Wednesda y, August 18, 1999 3:59 PM