![](/images/new-backgrounds/1009569/956931x1.webp)
5.Place one of the supplied num- bered stickers on the sensor transmitter to show its zone num- ber.
6.Leave the console’s switch set to INSTALL to install other accesso- ries.
Repeat these steps for additional door/ window sensor transmitters.
INITIALIZING THE MOTION DETECTOR
1.Press the four dots on the battery compartment cover and slide the cover down to remove it.
MOTION DETECTOR
2.Install four 1.5V AA alkaline bat- teries (Cat. No.
16
3.Be sure the console’s INSTALL/ RUN 1/RUN 2 switch is set to
INSTALL.
4.Press TEST on the back of the motion detector. The console chimes, and the first available zone indicator lights to show the console has logged in the motion detector.
TEST | CODE |
If you do not hear a chime, press CODE with a pencil, then press TEST again.
5.Looking at the back of the motion detector, set the switch on the left side to 1 (see “Mounting the Motion Detector”).
1
2
6.Place one of the supplied num- bered stickers on the motion detector to show its zone number.
7.Leave the console’s switch set to INSTALL to install other accesso- ries.
8.Replace the motion detector’s bat- tery compartment cover.