Manuals / Radio Shack / Home Audio / Speaker

Radio Shack 920SR aux out - connecting to personal FM devices, PE 571T OR, PE 300T OR PE 300TS

Models: 920SR

1 67

Download 67 pages 35.46 Kb

Page 50

Image 50

aux out – connecting to personal FM devices

connecting to SOLARIS, EASY LISTENER, SPRITE or other transmitter

(for rebroadcast of audio to students with hearing impairment)

AT0529AAT0532-05

Ant jack

Aux In

2 1

1Connect AT0532-05(ft) cord to AUX input jack of either SOLARIS, EASY LISTENER, SPRITE, or other trans- mitter. Connect other end of cable to AUX OUT port on top of speaker.

2Connect antenna AT0529A (included with transmitter system) to Mic/Ant jack on transmitter

3Refer to level setting gide on next page to identify proper level for your transmitter

PE 571T OR

PE 300T OR PE 300TS

Page 50

Image 50

Radio Shack 920SR manual aux out - connecting to personal FM devices, PE 571T OR, PE 300T OR PE 300TS

Contents

922T handheld transmitter 923C charging stand 216MHz920SR speaker 921T body-worntransmitter user guide920SR speaker placement contentssystem setup and operation aux in - connecting tointroduction with sound field understanding sound field and its benefitswithout sound field setup tips Basic setup tipssetup tips cont’d setup tips cont’d If mounting on the wall, consider the followingIn the evening after each use daily operating tipsIn the morning daily operating tips cont’d Battery care and maintenance tipsdaily operating tips cont’d Do not coil the microphone - since it also acts as your antenna, coiling or wrapping the cord will affect its range and may also reduce its lifeparts and accessories included with system and orand/or 920SR column speaker features top 3reception status indicator for channel B 920SR column speaker features front and back 18power and charging indicator power jack16handle 17main power on/off switch 15internal rechargeable battery non-userremovableback 921T body-worntransmitter featuresfront 6 3 position power switch 921T body-worntransmitter features cont’d1belt clip 2battery compartment 3 volume control 7 power and low battery indicator lightbattery compartment 922T handheld microphone features1 LED indicator light 2 3 position power switch inside battery compartment2 pocket 1 charging indicator 923C charging stand featuresfront 1 power indicator 3 pocket 1 full charge indicator1Attach antenna to top of speaker system setup and operationattach antenna 1Plug power supply into power/charging socket 2 turn on main powerif using wall outlet Plug power supply into wall socketcharge battery insert batteries in body-worntransmitter Switch power offRemove battery cover NiMH batteriesInsert two AA rechargeable 3 NiMH batteries 1 Switch power offinsert batteries in handheld microphone Remove battery covercharge transmitters Plug power supply AT0819 into5 When green charge ready indicator on back of charger stand1 PWR wait until green charge indicators light 4-5hours4 ERROR 2 CHARGINGselect channel matchactivate receivers setting FM volume See setup tips on page 920SR speaker placement and mountingets or place speaker on a surface using a speaker positioning= suggested placement of 920SR speaker hallwayhallway hallwaywall mounting option 1Attach brackets to wallTurn counter-clockwiseto loosen mounting on floor stand optionTurn clockwise to tighten AT0824 floor stand is also availableseal wall mounting hole if using table stand 921T body-worntransmitter operation plug microphone inAT0814 earhook mic battery life 16 turn power on1Switch power on 2Check indicator light 17 adjust transmitters frequency 1 greater mic sensitivity and sound clarity adjust body-worntransmitter volumeIncrease transmitter volume for back occursactivate standby/mute mode 922T handheld transmitter operation turn power onswitch up NiMH rechargeable AA = 12 hours approx 21 check indicator light1 Check indicator light Alkaline disposable AA = 15 hours approxremove channel adjustment key 2Remove channel adjustment keyPage 24 standby mode Activate standby mode to mutecompatible accessorytransmitter performanceaux in - connecting to TV, CD, VCR, etc connecting speaker to TV, CD, VCR, etcPE 300T OR PE 300TS aux out - connecting to personal FM devicesPE 571T OR aux in jack size aux out level settingproduct name/part microphone options additional system accessoriesreceiver accessories NiMH batteries additional system accessories cont’dtransmitter accessories AA rechargeablefeedback from speaker troubleshootingweak sound from speaker speaker is picking up FM interference or hum troubleshooting cont’dspeaker battery does not charge Channel A Channel #Channel # Channel Bproduct specifications two channel column speaker 920SRproduct specifications cont’d body-worntransmitter 921Tbattery life product specifications cont’dbattery weightwhat is covered by this warranty warrantytime period of warranty what is not covered by this warrantywhat to do if you have questions warranty cont’dwhat to do if you need service USA/International Phonic Ear Inc warranty cont’davoid battery corrosion 3880 Cypress Drive Petaluma, CA U.S.A In Canadaregulatory approvals and clearances transmitterregulatory approvals and clearances cont’d receiver part 15, subpart BPart regulatory approvals and clearances cont’dFCC notes regulatory approvals and clearances cont’d IC notes821-7403-101/Rev.D/4724