5.Route the adapter’s cord through the strain relief slot on the bottom of the bracket.
6.Plug the adapter into a standard AC out- let.
7.Lift the base’s antenna to a vertical posi- tion.
On a Wall Plate or Wall
plate studs and slide the phone down- ward to secure it.
1.Insert the bracket’s tabs into the base’s lower tab slots, then press down on the bracket’s clips and insert them into the clip slots.
2.Plug one end of the supplied short mod- ular cord into the TEL LINE jack on the back of the base.
3.Insert the supplied AC adapter’s barrel plug into the DC IN 9V jack.
4.Route the adapter cord through the groove on the bracket.
5.Plug the modular cord’s other end into the wall plate jack, then align the bracket’s keyhole slots with the wall
6.Plug the adapter into a standard AC out- let.
7.Lift the base’s antenna to a vertical posi- tion.
Note: To mount the phone directly on a wall, you need two screws (not supplied) with heads that fit into the keyhole slots on the bottom of the base.
Follow the steps under “On a Wall Plate or Wall,” then apply these additional instruc- tions.
1.Drill two holes 315/16 inches (100 mm) apart. Then thread a screw into each hole, letting the heads extend about 1/8 inch (3 mm) from the wall.
2.Plug one end of the supplied long modu- lar cord into the TEL LINE jack on the back of the base and route the adapter cable and modular cords through the grooves on the bracket.
3.Align the bracket’s keyhole slots with the mounting screws and slide the phone downward to secure it.
10 | Installation |
