Follow these steps to store a number and name in the handset.
1.Lift the handset.
2.Hold down MEM until C[cehoýIjeh[ and a list of memory location numbers (and names, if any) appear.
3.Select an empty memory location (or the
one you want to replace) by using VOL/ CID 8 or 9 to scroll through the list or entering the location number
Note: If the phone sounds five quick beeps, you have made an entry error and the number was not stored. Reenter the location number correctly.
4.Press SELECT/INTCM. Ijeh[ DWc[ appears. If you do not want to enter a name, skip to Step 6.
5.To enter a name, use the number keys.
Refer to the letters on the number keys to select the desired letter. Press the key once for the first letter in the upper case, press twice for the second letter in the upper case, and so on. To enter the lower case letter, press four times (or five times) to display the first letter in lower case, five or six times for the sec- ond letter, and so on.
For example, to enter John: press 5 once; upper case @ appears. Then press 6 six times; lower case e appears. Press 4 five times; lower case ^ appears. Finally, press 6 five times; lower case d appears.
To enter two letters from the same key in a row, press FLASH7 to move the cur- sor to the next position. For example to
enter AB, press 2; 7 appears. Then press FLASH7, the cursor moves to the
next position, then press 2 twice so 8 appears.
To enter a space, press FLASH7 twice without entering any character.
To enter a number, repeatedly press the corresponding number key until the number appears.
To enter special character, use 0. Each time you press 0, the following charac- ters appear in this order:
∗# – &ý( ) (space) 0
If you make a mistake, use REDIAL6or FLASH7 to move the cursor over the error, then enter the correct character, or press DELETE/CH to delete a character. To delete all characters, hold down DELETE/CH for at least 1 second.
6.Press SELECT/INTCM. Ijeh[ DkcX[h appears.
7.Enter the phone number and any tone or pause entries (see “Entering a Pause” on Page 19).
If you make a mistake, use the same method to correct it as described in Step 5.
8.Press SELECT/INTCM. The phone beeps and C[cehodd Ijeh[Z (nn stands for the memory location number you assigned) appears. After 2 seconds, C[ceho Ijeh[ appears. Repeat Steps
9.When you finish, press MEM.
To replace a stored number, store a new one in its place (see “Editing or Deleting a Num- ber in the Handset's Memory” on Page 19).
18 | Operation |
