CONNECTING THE
PHONE
Plug one end of the supplied modular cord into the jack on the back of the
CONNECTING THE
HANDSET
Plug one end of the supplied coiled modular cord into the jack on the left side of the phone and the other end into the jack on the
handset. Then place the handset on the base.
SETTING THE DIALING MODE
Set TONE/PULSE on the back of the base for the type of service you have. If you are not sure which type you have, do this test.
1. Be sure TONE/PULSE is set to TONE.
TONE/PULSE
2.Lift the handset and listen for the dial tone.
3.Press any number except 0.
Note: If your phone system requires that you enter an access code (9, for exam- ple) before you dial an outside number, do not press that number.
If the dial tone stops, you have touch- tone service. Leave TONE/PULSE set to TONE.
If the dial tone continues, you have pulse service. Set TONE/PULSE to
PULSE.
SETTING THE RINGER’S VOLUME
Set RINGER OFF/LO/HI on the back of the base to LO for a normal ringer vol- ume, or HI for a louder ring.
RINGER OFF/LO/HI
7
