Directly on the Wall
To mount the system on a wall, follow these steps.
| 1 |
|
| 1/4 |
Note: For direct wall mounting, drill two holes 3 /4 |
|
|
| |
inches (82.5 mm) apart, one below the other. Then |
|
|
| |
thread two screws (not supplied) into each hole, let- |
|
|
| |
ting the heads extend about 1/4 inch (6.3 mm) from |
|
|
| |
the wall. (Be sure to use screws with heads that fit | 3 | 1 | /4 | |
into the keyhole slots on the bottom of the system.) |
| |||
|
|
| ||
1. Plug one end of the supplied long modular cord |
|
|
| |
into the modular jack on the bottom of the sys- |
|
|
| |
tem near its back end. |
|
|
|
|
2. Route the phone cord into |
|
|
|
|
the groove on the bottom |
|
|
|
|
of the system by sliding |
|
|
|
|
the cord under the tabs | Modular |
|
|
|
along the groove. |
|
|
| |
Jack |
|
|
| |
|
|
|
| |
3. Plug the other end of the |
|
|
|
|
cord into a modular phone | Tabs |
|
|
|
jack. |
|
|
| |
4.Fit the heads of the screws into the keyhole slots on the bottom of the system, then slide the sys- tem down until it is secure.
Phone
Cord
Groove
Handset | Handset | Keyhole | |
Jack | Slots | ||
Groove | |||
|
|
Installation | 13 |
