14 Installation

On the Wall Plate

1. Plug one end of the supplied short modular cord into the
modular jack on the bottom of the system near its back end.
2. Route the phone cord into the groove on the bottom of the
system by sliding the cord under the first two tabs along the
groove. Then route the cord into the groove leading to the
center rectangular space.
3. Plug the other end of the cord into a modular phone jack
wall plate. Press any excess length of cord into the rectan-
gular space on the bottom of the system to keep it out of
the way.
4. Fit the wall plate studs into the keyhole slots on the bottom
of the system, then slide the system down until it is secure.
CONNECTING THE HANDSET
1. To connect the handset to the base of the system, plug one
end of the supplied coiled cord into the modular jack on the
handset.
2. Plug the other end into the jack on the bottom of the system
near its front end.
3. Route the handset cord into its groove on the bottom of the
system by sliding the cord under the tab.
4. Place the handset in the cradle.
Note: Your local RadioShack store sells a variety of longer
coiled handset cords, which are useful when you mount the sys-
tem on a wall.
43-3804.fm Page 14 Thursday, July 6, 2000 2:35 PM