31
Remote Operation
• listen to your messages
• delete individual or all messages
REMOTE OPERATION SECURITY CODE
To use your answering system from a remote telephone, you
must first enter a 3-digit remote operation security code. (The
default security code is on a label located on the bottom of the
system.) Enter the security code within about 7 seconds after
the system answers and sounds 2 beeps. Within 10 more sec-
onds, enter a remote command.
OPERATING THE ANSWERING SYSTEM FROM A REMOTE LOCATION
1. Dial your phone number. Even if the system is not set to
answer calls, it answers after about 10 rings.
2. After the outgoing message plays and the system beeps,
enter your remote operation security code.
Note: If you pause for 10 seconds between digits, the sys-
tem hangs up.
3. Enter a remote command (see “Remote Commands” on
Page 32).
4. When you finish, press 5# to end remote access.
43-3804.fm Page 31 Thursday, July 6, 2000 2:35 PM