43-1083.fm Page 18 Tuesday, August 17, 1999 2:17 PM

CHANGING CHANNELS

The ET-908 continuously scans 10 channels (frequency pairs used be- tween the base and the handset) and automatically selects the one with the least interference each time you make or receive a call.

If you notice interference during a call, however, you can repeatedly press CH (channel) to try and find a clearer channel. The ET-908 changes to a dif- ferent channel each time you press the key.

 

 

 

PRIVACY / LOW BATT

 

TALK

CH

OFF

CH

1

ABC 2

DEF 3

Note: You cannot change the channel while using HOLD.

18

USING MEMORY

DIALING

You can store up to 10 numbers in the ET-908’s memory, then dial them at the press of a few buttons.

Note: Each phone number can be up to 16 digits long.

Storing a Number in Memory

Note: You must complete Steps 1-3 within 30 seconds of each other. If you do not, the ET-908 sounds a long beep, all indicators stop flashing, and you must start over again at Step 1.

1.Press PROG. The TALK indicator flashes.

2.Press the number key (0-9) of the memory location where you want to store the phone number.

3.Enter the phone number you want to store (up to 16 digits).

Notes:

To store the last number you dialed, you can simply press

REDIAL.

You can store special banking or telephone service numbers (such as access codes or account numbers) in memory.

Page 18
Image 18
Radio Shack ET-908 owner manual Changing Channels, Using Memory Dialing, Storing a Number in Memory