Radio Shack ET-908 owner manual Adjusting Ringer, Checking/Setting the Ringer Type

43-1083.fm Page 13 Tuesday, August 17, 1999 2:17 PM

SETTING THE PULSE/ TONE SWITCH

Set PULSE/TONE for the type of service you have. If you are not sure which type you have, do this test.

1.Set PULSE/TONE to TONE.

PULSE TONE

2.Press TALK on the handset and listen for a dial tone. The indicator above TALK turns on.

TALK		PRIVACY / LOW BATT
TALK	CH	OFF
1	ABC 2	DEF 3

3.Press any number other than 0.

If the dial tone stops, you have touch tone service. Leave PULSE/ TONE set to TONE.

If the tone continues, you have pulse service. Set PULSE/TONE to

PULSE.

4.To hang up, either place the hand- set on the base or press OFF on the handset.

ADJUSTING THE

RINGER

Checking/Setting the Ringer Type

The ET-908 is preset to use ringer type

1.To check or change the ringer type, follow these steps.

1.Press PROG. The indicator above TALK flashes.

		PRIVACY / LOW BATT
TALK	CH	OFF
1	ABC 2	DEF 3
GHI 4	JKL 5	MNO 6
PRS 7	TUV 8	WXY 9
TONE	OPER0	#	PROG
HOLD	FLASH
MEM	PROG	REDIAL

2.Within 30 seconds, press #, then press 1-4(one key after the other) to hear the different ringer types. The ET-908 sounds a different ringer type for each key.

Notes:

•To hear the currently selected ringer type, press 0 anytime after you press # during this step.

•If the indicator above TALK turns off before you make your selection, press PROG again then repeat this step.

3.When you hear the ringer type you want to use, press # to select it. The indicator turns off.

13