Note: You can set the control to any other position (except 0). However, to get an accurate pre- set, all the volume controls must set to the exact same position.
(illus)
5.While you use the microphone, insert a flat bladed screwdriver into the slot above the corre- sponding volume control and adjust it until you obtain a reading of 0 on the OUTPUT LEVEL VU meters.
(illus)
6.Temporarily set the MIC main vol- ume control to 0.
7.Repeat Steps 4 through 7 to con- nect and adjust the preset levels of all your other audio input sources.
Notes:
•Do not connect the
(ceramic) jacks.
•Except for the PHONO ceramic inputs, you can connect any high- level audio source (tuner, cassette tape deck, CD player, magnetic- cartridge turntable, or VCR) to any set of input jacks.
•Connect the ground wires (usually black or green) from your mag- netic cartridge turntable to the GND screw terminal on the back of the mixer.
PRE-ADJUSTING THE MONITOR LEVELS
To listen in privacy or monitor the au- dio source inputs so you can locate an exact passage or section before mix- ing it into the MAIN OUTPUT, insert a pair of stereo headphones (not sup- plied) equipped with a
(illus)
1.Set the volume control of the input sources to be monitored to their minimum settings.
5
