TROUBLESHOOTING
If you have problems using your
Problem | Suggestion | |
|
| |
|
| |
The incoming message is incom- | Be sure the memory is not full. | |
plete. |
| |
The caller’s message was longer than 60 sec- | ||
| ||
| onds. | |
|
| |
| The caller was silent for over 8 seconds. | |
|
| |
The incoming message is | Adjust VOLUME. | |
unclear. |
| |
|
| |
The | Be sure the TAD is set to answer calls. | |
after two, four, or seven rings. |
| |
|
| |
ANSWER indicator flashes. | The backup battery is weak or missing. | |
| Replace the battery (see “Installing the Backup | |
| Battery” on Page 5). | |
|
| |
The | Make sure the phone you used to dial the TAD | |
to the remote operation security | is a | |
code. | a pocket tone dialer to enter the code and com- | |
| mands.) | |
|
| |
| ||
|
| |
| The remote operation security code might have | |
| reset to the default code due to a power failure. | |
| Make sure the code you entered is correct. | |
|
| |
You cannot record an incoming | Be sure the | |
message. |
| |
Be sure the memory is not full. | ||
| ||
|
|
RESETTING THE TAD-1027
If your
Note: The outgoing messages and all information stored in memory are erased when you reset the TAD.
16