INSTALLATION
ATTACHING THE MICROPHONE HOLDER
You can connect the microphone hold- er to the right side of the transceiver or to another location in your vehicle.
To attach the holder to the transceiver, secure it with the supplied mounting screws and lockwashers.
3.Attach the holder at the mounting location using the supplied mount- ing screws, lockwashers, wash- ers, and nuts.
To attach the holder to another loca- tion in the vehicle, such as the dash- board, follow these steps.
1.Using the holder as a template, mark the positions for the mount- ing screw holes at the desired location.
2.At each marked position, drill a hole slightly smaller than the sup- plied mounting screws.
Caution: Be careful not to drill into anything behind the mount- ing surface.
MOUNTING THE TRC-442
The most common mounting location for this CB is under a vehicle’s dash- board. However, if you use the TRC- 442 as a base station, you can place it on a desk, shelf, or table. See “Using the CB as a Base Station” on Page 9.
If you are mounting the CB in a vehi- cle, choose a location where:
•You can easily reach the CB.
•Wires and cables are clear of the vehicle’s pedals or other moving parts.
•The CB is not directly in front of heating vents.
•All wires and cables can reach their connection points.
5
