Radio Shack Trunk Mount owner manual Replacing The Fuses, Replacing the Tube-TypeFuse, Cautions

12-1976.fm Page 21 Tuesday, July 13, 1999 10:01 AM

REPLACING THE FUSES

If the amplifier shuts down, you might need to replace the power wire’s 10-amp tube-type fuse (such as Cat. No. 270-1072, not supplied), the 10-amp blade-type fuse (such as Cat. No. 270-1081, not supplied) on the back panel, or both fuses.

Cautions:

•Do not use fuses with ratings other than those specified here. Doing so might damage your amplifier.

•After replacing a fuse, let the amplifier cool down before you turn it on again.

Turn off your autosound system, then disconnect your vehicle battery’s negative (-) terminal.

Replacing the Tube-Type Fuse

1.Grasp the two ends of the power wire’s fuse holder and twist them counterclockwise, then pull the ends apart.

2.Insert a new 10-amp, tube-type fuse into the longer of the two fuse-holder’s ends, then grasp the fuse-holder’s two ends, push them in and twist them clockwise to secure them.

Replacing the Blade-Type Fuse

1.Grasp the fuse’s plastic end and pull it out.

2.Grasp the new fuse’s plastic end and simply push it in.

21