Radio Shack Trunk Mount owner manual Connecting Your Autosound System, Low Level Input Connections

12-1976.fm Page 7 Tuesday, July 13, 1999 10:01 AM

CONNECTING YOUR AUTOSOUND SYSTEM

Low Level Input Connections

You can connect your autosound system’s low-level phono output jacks to the amplifier’s LOW INPUT phono jacks.

Note: For a cleaner, less noisy signal transfer between your autosound system and the amplifier, the amplifier’s LOW INPUT phono jacks are gold-plated.

For the best results, use shielded audio cables, such as Cat. No. 42-2368 (not supplied). If your autosound system has only two phono outputs, you will also need two shielded Y-adapter cables, such as Cat. No. 42-2435 (not supplied).

1.Temporarily place the amplifier as close as possible to the selected mount- ing location.

2.If your autosound system has four phono outputs and you are using four speakers, connect the autosound system to the amplifier using audio cables as follows: front-left to FRONT L, front-right to FRONT R, rear-left to REAR L, and rear-right to REAR R:

7