4. INTENDED USE

The machine has been designed and manufactured to obtain espresso and other hot beverages (tea, cappuccino, etc.).

This machine is only intended for the purposes for which it was designed. Any other use is to be considered unsuitable and therefore dangerous.

The user must always follow the indications contai- ned in this manual. If the machine is not working properly, switch it off and do not attempt any direct repair. For service, contact the retailer.

The user must not:

•Touch the hot surfaces of the machine with his hands, but use only proper the controls;

Transport the machine or carry out maintenance operations with the plug connected and when the machine is warm;

Use the machine if the supply cable is damaged

•Touch the machine with wet or damp hands or feet

Overturn or place the packaging on one side

Wash the machine with water or vapour jet

Dip the machine in water or other liquid

Use the machine when there are children in close proximity

Allow the machine to be used by children or inca- pable persons

Obstruct the aspirations or heat dissipation grills

• Place containers with liquids on the machine

It is forbidden to install or use the machine if it is wet or damp.

It is always necessary to request an accurate check by qualified personnel in order to find any possible damages to the electric components.

This machine may be used only for the purposes for which it was designed. It cannot be used to dispense products other than coffee or any non food products.

The manufacturer cannot be held responsible for any damage caused by unsuitable, erroneous or irrational use of the machine.

5.TRANSPORT

5.1.Packaging

The machine must always be transported in the correct position following the instructions on the cardboard box.

Do not turn over the machine or lay it down on its side.

The box also contains separate accessories and technical documentation which must be saved for further consultation.

Open the top part of the packaging, remove the accessories and then remove the machine from its packaging.

Check if the machine, the accessories, the electric cable and the plug are in perfect condition. Should one of these parts be damaged, immediately con- tact the retailer.

The packing elements (plastic bags, expanded polystyrene, nails, cardboard, etc.) must not be left within reach of children as they are potential sources of danger.

Do not dispose of the packing elements in the environment; consign them to firms authorized for their disposal.

6. INSTALLATION

The machine is delivered ready to be installed in accordance to the label data.

Ensure that the electrical supply system has the same features as the machine.

The electrical supply system must be equipped with a GFI (ground-fault interrupt) or a general automatic switch with an efficient grounding system. Should there be no electrical protection element, have a single- pole switch installed by qualified personnel, as outlined by the current safety regulations with a contact opening distance of either equivalent or over 3 mm.

The grounding of the appliance is man- datory.

The manufacturer declines all responsibility in the event of failure to respect the accident prevention norms.

Take care not to damage the supply cable by placing undue weight upon it.

Do not disconnect the machine by pulling the cable, but instead by gripping the plug.

33