ISTALLATION
TECHNICAL INSTRUCTIONS FOR THE INSTALLER
The installation and service procedures given below may only be carried out by a competent technician. Failure to install the appliance correctly could be dangerous and invalidate any warranty or liability claims. The manufacturer cannot be held responsible for any damage to persons or property caused by incorrect installation or use of the appliance.
1) Preparation
After unpacking the hob, make sure it is complete and undamaged.
Please keep children away from all packaging (carton, polystyrene, nails,..).
Make a cutout in the worktop, according to the dimensions shown in fig. 5; make sure that the installation will comply with the critical clearance dimensions (fig. 5 and 6).
Fig. 5
Fig. 6
2) FIXING
- Screw the fixing brackets to the hob (fig 7).
Fig. 7
-Turn the hob over. Carefully fit the seal (“E” in fig.
8)under the hob edge but don’t remove the protective paper strip. Stick the seal to the hotplate uniformly, pressing it with your fingers. The ends of the strip must fit together without overlapping.
Fig. 8
-Take the protective paper strip off the seal, place the hotplate in the opening made in the work top, and lock it in place with the special screws (“F” in fig. 9).
Fig. 9
IMPORTANT:
The glue used to fix plastic laminate to worktop, has to be able to withstand 150° C, to avoid delaminating. This appliance is type Y with regard to protection against over heating of the surrounding surfaces. The rear wall, adjacent and surrounding surfaces must therefore be able to withstand a
5