INSTALLATION

SERVICING

Before doing any servicing, disconnect the appliance from the power supply.

7) Replacing parts

To replace internal components it is necessary to remove the appliance from the worktop. Turn the hob over, loosen the screws and remove the base. It is possible to work on the plates, controls, clamps and input cable.

When replacing the input cable, keep the “earth” conductor longer than “live” ones. Follow the advice given in “Electrical connection” section.

To reassemble the appliance repeat the inverse process.

5) Technical Data

ElementW

Ø145 mm element 1200

Ø180 mm element 1700

Voltage

230 - 240/400 - 415 V

3N~

 

Frequency

50/60 Hz

Tot. Rating

5800 W

TECHNICAL ASSISTANCE AND SPARE PARTS

Before leaving the factory, this appliance will have been tested and regulated by expert and specialized personnel in order to guarantee the best performances.

Only qualified engineers should carry out any repairs or adjustments. Do not use re-conditioned or unauthorized controls.

If repairs or adjustments are required, contact our service provider on 0845 6035312 specifying the type of fault and the model of the appliance. This information is printed on the data label on the base of the hotplate.

Please fill in the following information so that you have it to hand if you have to call for service.

MARK: .............................................................................

MODEL: ...........................................................................

SERIES: ...........................................................................

7