INSTALLATION
Hood body mounting
•Firstly, it is necessary to adjust the two
•Hang the hood body on the two brackets 11a.
•Connect the hood to the mains supply by means of a bipolar switch with at least 3 mm contact gap.
•Press the
•Remove the metal filters.
•In order to align the hood it is necessary to adjust the
•Fasten the safety screw 11.
•Fit again the metal filters into their seats and close the upper panel by pressing
•Disconnect the hood from the mains supply.
Attention: the upper panel stops if any barrier occurs in its way during the panel opening or closing. To open the panel it is enough to remove the barrier and press the key once again.
A | L |
| 11a |
| Vr |
| ( B ) |
| 11 |
Connections
DUCTED VERSION AIR EXHAUST SYSTEM
When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 125 mm, the choice of which is left to the installer.
•To install a ø 125 mm air exhaust connection, insert the reducer flange 9 on the hood body air outlet and the adapting ring
•Fix the pipe in position using sufficient pipe clamps (not supplied).
•Remove any activated charcoal filters.
ø 150 | ø 125 |
9 | 10 |
|
EN |
| 6 |
| 6 |