Rangemaster R7247 manual Positioning the Oven, Provision for Ventilation, Installation

INSTALLATION

Check the appliance is electrically safe when you have finished.

Fig.7-1

������

���

���

���������

��

��������������	���
���������������������������������
���

All dimensions in mm

������

Positioning the Oven

The oven can be installed under a worktop (Fig.7-1)and is designed to fit into a 600mm wide opening between two kitchen units.

The oven is 594mm across the trims and an unrestricted opening of 540mm minimum depth is needed, as measured from the front of the cabinet door to the rear of the housing.

The worktop and any associated hob should be fitted BEFORE installing this oven.

It is recommended that if installing a built-in oven directly under the hob then there should be a minimum air gap of 20mm between the oven and the bottom of the hob. Failure to maintain a suitable clearance may impair the performance of the hob.

Surfaces of furniture and walls adjacent to the appliance should be heat, splash and steam resistant. All cabinet doors must be at least 8mm from the oven at all points.

Certain types of vinyl or laminate kitchen furniture are particularly prone to heat damage and discolouration. We cannot accept responsibility for damage caused by normal use of the appliance to any material that de-laminates

or discolours at temperatures less than 65°C above room temperature.

When placing the oven in the housing, do not use the oven door as a lever for lifting the oven as damage may result. Once the oven is in position in the housing, use suitable screws to secure in place.

Provision for Ventilation

The appliance housing used must provide adequate ventilation. If installing into a 600mm housing, an opening of at least 50mm deep must be cut in both the top and bottom of the housing unit to provide sufficient ventilation.

12